HOTT Electric Air-Modul 2-14s Vario

HOTT Electric Air-Modul 2-14s Vario

Functions:


Vario with altitude signals and 5 climb and 5 drop signal sounds, plus additional warning thresholds for min. altitude, max. altitude, climb and drop speeds in two stages
Altitude display (- 500 ... + 3000 m) and storage of the min. and max. altitude.
2x temperature and voltage measurements with warning thresholds for min. and max. voltage and min. and max. temperature
Single cell measurement 2 ... 14S with warning thresholds for min. voltage
Voltage, current and capacity measurement with warning thresholds for min. and max. voltage, max. capacity and max. current
Programmable current limiting
Current measurement with shunt resistors 2x 0.2 mOhm (5 W) parallel = 0.1 mOhm
Adjustable warning time: OFF, 5, 10, 15, 20, 25, 30 seconds, always
Adjustable warning repetition time: Always, 1, 2, 3, 4, 5 min, once


Important Note when using the modules 33600, 33601, 33610, 33611 and 33620:
Do not carry out any programming work on the sensors while the model is flying, otherwise there is a real risk that your model will fly out of control while you are not concentrating on it!
If your model is fitted with two or more receivers, it is absolutely essential that you do not carry out programming work during a flight, as this can alter the settings in the receivers to which no telemetry equipment is connected; in the worst Case this could result in the model crashing! For this reason always carry out programming on the ground, and check that only the receiver with connected sensor is powered on.

Connections and Technical data Vario:

2x temperature selectively 0 to 120°C or 200°C and voltage measurement up to 60 V DC
1x speed controller input, 1x speed controller output for single cell undervoltage correction
1x current and voltage and capacity measurement up to 150 A (short-term 1 sec 320 A) and up to 60 V DC
1x single cell monitoring for 2 - 14S lithium batteries (LiPo, LiIo, LiFe)
1x telemetry connection for receiver
Altitude measurement: -500 m ... +3000 m
Resolution: 0.1m
Vario sensitivity: 0.5 m/3 s, 1 m/3 s, 0.5 m/s, 1 m/1 s, 3 m/s programmable by tone
Average calculation: 4 - 20 measurementsprogrammable per measurement value

Specification

Dimensions (LxWxH): 51 x 47 x 18 mm
Operating voltage : 3,6 ... 8,4 V