Piper Cub "Clip Wing" - lasercut wood KIT - 762 mm - Dumas Aircraft

Piper Cub "Clip Wing" - lasercut wood KIT - 762 mm - Dumas Aircraft

Piper "Clip Wing" Cup Lasercut Balsa kit - as a rubber motor flight model.

The wooden kit made of hand-selected balsa wood from DUMAS contains over 140 parts manufactured with more precise laser technology.
The neatly fitting parts require almost no rework and this shortens the construction time considerably compared to stamped balsa parts.
A very detailed plan and building instructions (only in English) leave no questions unanswered.

Features of the DUMAS rubber motor models
* Lasered frames and ribs
* The balsa wood in the kit was selected by hand
* Special plastic propeller for rubber motor drive
* F.A.I. approved rubber for the drive
* Construction plan in the original size of the model
* Step by step assembly instructions
* Thermoformed plastic parts (if required for the kit)
* Colored stickers (if required for the kit)
* Colored covering paper included in the kit

Currently, a building description is only available in English.


Technical specifications:

Span 762mm
Construction / Material
Material hull wooden parts
Material surface wooden parts
Lasered fuselage construction
Surface construction ribs lasered
Covering paper

The RC expansion can be accomplished by the experienced model builder without any major problems. The following parts are required for this:
Brushless motor (approx. 15-25 g)
Brushless controller (approx. 5-10A)
Lipo battery 2s 350-500mAh
2-4 micro servos with 4-6g (rudder, elevator. Optional: aileron)


Recommended for the advanced model builder and pilot.
When used as a rubber motor model, even a beginner can get along well with the construction and the flights.