RCHUNGARY @ Social Media

Most popular products

RCHUNGARY Pick-up Point - Opening times:
Mon, Tue, Thu, Fri : 9:00 - 17:00 // Wed: closed 
Sat: 9:00 - 13:00 -
only on following dates in 2024: Dec. 7+14+21+28
RCHUNGARY will remain closed on following days: Dec. 24-25-26-29-31 // 2025: Jan. 1 - 5

Address: József Attila utca 55/B, 2011 Budakalász, Hungary   Tel: +36 26 340009     E-mail: info@rchungary.com   


Free delivery as of 38 000 Forint (valid for Hungarian addresses with FoxPost, ExpressOne and MPL deliveries only)


 

UHU wood glue waterproof 75 g

UHU wood glue waterproof  75 g
UHU wood glue waterproof 75 g
UHU wood glue waterproof 75 g
Details
In stock
5.54
Details
UHU wood glue waterproof 75 g

PROPERTIES
Waterproof (EN 204 D3)
Stronger than wood
Ideal for indoor and outdoor applications
Clear after drying
Paintable
Solvent free

APPLICATION - SUITABLE FOR:
Suitable for waterproof bonding and laminating of practically all soft, hard and exotic wood species. Suitable for well fitting non load bearing timber structures where finger, dovetail and tenon joints, dowels and springs have been used. Suitable for indoor and outdoor applications, especially for glued joints that need to be waterproof. For surface bonding of wood, insulating boards, chipboard, multiplex plywood, MDF, paper, cardboard and hardboard. Also suitable for laminating veneer and hard plastic panels (HPL, Formica, Duropal, Resopal) on wooden surfaces. D3: Indoor areas where running water, condensation and/or high exposure to relative humidity occur regularly but for short periods of time. Outdoor areas that are not exposed to the weather conditions.


PREPARATION
The ambient temperature, the temperature of the adhesive and the materials to be bonded should not be below +5 °C. The relative humidity should not exceed 65%. The moisture content of the wood should be between 8% and 12%.

surface requirements
The surfaces to be bonded must be clean, dry and dust-free. Make sure the surfaces to be joined are a good fit.

Preparation of the surfaces
Degrease oily wood with solvents.

aids
Fine-toothed glue spreader (1 mm), brush or roller, clamp or press.

dilution
Can be diluted with water

consumption
2 - 4 m²/kg, applied on both sides, depending on the material properties.

PROCESSING:
Using a brush or other tool, apply the adhesive thinly and evenly to one or both parts. Let it sit for a few minutes, press the pieces together and let them sit with a clamp or press for 30-60 minutes. The most suitable pressure is 2 - 5 kg/cm².

stains/residue
Immediately remove adhesive residue with water. Dried adhesive residue can only be removed mechanically.

storage conditions
Close the container properly and store the product in a dry, cool and frost-free place.
Info
Producer/Distributor
UHU
Producer/Distributor item number
48510
Article No.
19448510