Details
PEP - wood KIT - 1000 mm - Graupner
PEP - after a short building fun comes the flying fun - the PEP does everything you want :-)
The small model is a lot of fun to fly, gymnastics around close to the ground, sailing on slopes or climbing in the thermals without propulsion with the propeller folded.
The PEP is an electric glider that you can always take with you and does not overwhelm even inexperienced RC pilots.
Due to its low wing loading and the coordinated drive, the base speed is relatively low.
The particularly good-natured stall behavior also contributes to enjoyable flying.
Extremely low flying weight of only approx. 365 g - particularly maneuverable and agile - simple construction, wing and tail made of solid balsa -
Removable wing - easy battery replacement through a flap in the bottom of the fuselage
Technical data:
Wingspan: 1000mm
Length: 625mm
Flight weight: approx. 365 g
Total area: 13 dm3
Area loading: approx. 28g/dm3
RC functions: elevator, aileron, motor control
The kit contains:
Clear construction instructions in German & English with many detailed illustrations.
Laser cut boards made from balsa wood and plywood.
Profiled end strips and ailerons made of balsa wood.
Bowden cable for elevator.
Fasteners for engine and wing.
Decal sheet with punched out lettering.
Ready-to-use sanding block.
Required (not included):
Brushless motor, d: 28 mm, 1500-2000 KV, 35 - 50g
Brushless controller: from 15A (depending on motor)
Propeller: 7x4" - 8x5" (depending on engine)
Lipo battery: 2s 1100 - 2000mAH (3s possible, depending on motor)
Spinner: d: 33 - 36 mm
Servos: 3x 8g servos, min. pulling force 1.2kg, servo width approx. 8-11 mm
Remote control set with at least 4 channels
Wood glue, superglue, various craft tools
Recommended for:
Construction: Advanced beginner
Flight: Advanced Beginner - Professional